Could not connect to the NanoDLP. Please check your network connection.

Layer

Height

Remaining

ETA

Elapsed

Action
To Layer
Gcode Before
Wait Before
Cure Time
Wait After
Gcode After
Lift
Lift Wait

Enable Auto Shutdown   Start Display   Take Photo
Are you sure you want to stop printing? It will stop after the current layer is completed. If you want to abort the current layer, go to the `Setup` page, click on `Tools` tab and click the `Force Stop` button. Are you sure you want to power off the printer? Are you sure you want to power off the projector? Are you sure you want to start the display? It will automatically select the second display. Are you sure you want to restart the printer? Are you sure you want to resume the previous print?

Plates

pug

MCAST + Sylgard / 65micron (22.90ml)
-
01:41:18
18.00s / 3.90s
Are you sure you want to delete all plates? Are you sure you want to delete this plate? Are you sure you want to regenerate the layers of this plate? Are you sure you want to stop printing? Are you sure you want to print plate from the start? Are you sure you want to print the calibration plate?
ID Plate Details Date Action
1 pug

  MCAST + Sylgard / 65micron
  34x59x43mm / 65x47x30μm

  The plate is not sliced yet.
Slicing...
  Resin Usage
22.90ml
  Resin Cost
-
  Last Print
0 hours ago
  Print Time
01:41:18
  Cure Time
18.00s / 3.90s
Layer 558 of 1444